|
Usuarios conectados
Actualmente hay 6039 visitantes y 4 usuarios online.
|
Productos
|
Información
|
Destacado
|
|
|
|
|
No hay comentarios de productos.
1-2. Attention of i.LINK
The i.LINK compatible unit connected to this set is not recognized. Or, the message such as �Operation is disabled, as DV unit is not connected or the power is not turned on� is displayed.
t Disconnect the i.LINK cable once, and reconnect it. For further informa-
tion, see �Connecting i.LINK unit� of �Data transfer to i.LINK unit� in the �Extend� of the Online Manual for this set.
The unit connected to the i.LINK connector on the docking station does not operate normally.
t Use the i.LINK connector on this set.
The operation of i.LINK compatible unit connected to this set stopped.
t Finish the operation of the i.LINK compatible unit first, when removing
the docking station during the connection of i.LINK compatible unit.
The message �Recording to DV unit failed. Retry after checking the DV unit for power supply and connection state� is displayed during the recording on the tape using the �DVgate� software.
t Check if the power and connection cables are connected correctly to
the DV unit. Continuous recording may cause a recording failure even if the unit is connected correctly. In such a case, restart this set after exiting all of the software. To use the set in more comfortable environment, it is recommended to extend the memory. For further information, see �Extending the memory� (page 109).
The frames drop during the use of �DVgate� software.
t The frames may drop depending on the operating condition. In such a
case, extend the memory. For further information, see �Extending the memory� (page 109).
Confidential
PCGA-DSD5/DSM5 (UC) 1-2 (END)
|
|
|
> |
|