OKI OKIPAGE 12I/N
Manual de Servicio

3.3.2

TQSB-2 PCB (1) (2) (3) Remove the pulse motor (see 3.3.1). Remove the connector O from the TQSB-2 PCB P. Remove the screw Q and remove the TQSB-2 PCB P.

Note : Refer to Detall A in the previous page.
3.3.3 Hopping Roller Shaft Assy and One-way Clutch Gear (1) (2) Follow up to step (3) of 3.3.1 and remove the hopping frame assy. Remove the screw 1 and remove the earth plate 2. Remove the sensor lever 7 and remove the ground plate 6. Remove the gear 3 and remove the metal bush 5 and hopping roller shaft assy 4. Remove the E-ring A and remove the one-way clutch gear B on the right side of the feed roller 0.

(3)

Note : The metal bush C also comes off. Be careful not to lose it.

5

4

3 1 2

7 A C 6 B

0

9 8

40718301TH Rev.5

186 /