|
Usuarios conectados
Actualmente hay 6043 visitantes online.
|
Productos
|
Información
|
Destacado
|
|
|
|
|
No hay comentarios de productos.
Before Requesting Service
Disc picture
Picture distorted. There is ghosting when progressive output is on. Picture quality is poor. Menus not displayed correctly. �Some distortion is normal during search. �Change �Video Output Mode� in Picture Menu to �480I�. This problem is caused by the editing method or material used on DVD-Video, but should be corrected if you use interlace output. �Check the settings in the On-Screen Menu �Picture Menu�. �Change the zoom ratio to �k1.00�. �Set the subtitle position to 0. �Go to �Video� in the SETUP menu, and change �TV Aspect� to suit your TV. �Move the other equipment away from the TV as it may be picking up interference. �The connections were done incorrectly. Check the connections to the other equipment. �The external input channel �A1� or �A2�, to which the player is connected is not selected. Press [INPUT SELECT] to select �A1� or �A2�. �Copy-protected material was dubbed. Copy-protected materials cannot be recorded normally. Most commercially available videotapes and DVD discs (including rental soft tapes/DVDs) are copy-protected so that illegal dubbing is impossible. �Some discs may reproduce different audio levels. If the audio in particular parts, such as speech, is set to a low or high level, it may be recorded on a video cassette at a high or low level, respectively. �
13 39 37 34 41 � 17 17
Editing
Black bands appear in the recording. Recording video or audio from external equipment is not possible. A video was dubbed, but the video is distorted or the colours are abnormal. The audio level on the DVD section is not corresponding to that on the VHS section after editing.
�
�
Error Messages
On-screen display
PLEASE PUT IN A VIDEO CASSETTE. PLEASE STOP THE TAPE. PLEASE USE A CASSETTE WITH TAB. NO TIMER RECORDING HAS BEEN SET. Cannot display group xx, picture xx The progressive out is set to �Disable� �[REC¥] or [TIMER ] has been pressed without a video cassette inserted. Insert a video cassette with an intact erasure prevention tab. �TUNER PRESET has been selected during playback. Stop the tape. �[REC¥] or [TIMER ] has been pressed without a video cassette with an intact erasure prevention tab. Use a video cassette with an intact erasure prevention tab. �[TIMER ] has been pressed with no timer programmes. Set timer recording. �You are trying to display incompatible pictures. �Go to �Video� in the SETUP menu, and select �Enable (NTSC Disc Only)� in �Progressive Out (Component)�. 16, 18 22 4 18 � 41
Self-diagnostic Indications on the unit�s display
H��, F�� (�� stands for a number.) �An error has occurred. The number following �H� or �F� depends on the status of the unit. Reset procedure: Press [�/I] to switch the unit to the standby mode and then back to ON. Alternatively, press [�/I] to switch the unit to the standby mode, disconnect the AC mains lead, and then reconnect it. �If the service numbers fail to clear, note them and contact a qualified service person. �Disc is dirty. Wipe it clean. �You inserted a DVD-R which is not finalized. �You haven�t inserted a disc; insert one. �You haven�t inserted the disc correctly; insert it correctly. �You inserted a disc the unit cannot play. �You inserted a blank DVD-RAM. �A disc whose playback is restricted in the SETUP menu is inserted. Change the �Ratings� setting. �
� 5 5 � 26 5 � 41
CHECK DISC No DISC No PLAY
45
Helpful Hints
|
|
|
> |
|