10. Remove 1 screw holding thermistor on heater DU.
6.10. Bake fan motor and bake heater
1. Remove 6 screws and then move over rear cover.
11. Remove 6 screws holding heater DU & thermal cutout bracket on the bottom of oven assy. To install heater DU NOTE: 1.Spread silicon grease evenly between the interface of heater DU and bottom of oven cavity. (about 0.3mm thickness), this is for good conductibility. 2.Tighten 6 screws and make sure there is no gap between heater DU and bottom of oven cavity. 3.Do not forget to screw the thermal cutout bracket along with heater DU. To install thermistor NOTE: Before installing thermistor, please fill enough silicon grease into the installation hole of heater DU for good conductibility. 2. Disconnect 2 lead wires from the harness of noise filter (U), which are connected to both "Neutral" and "live" lead wire of oven circuit breaker.(black and white housing connectors) 3. Disconnect 2 lead wires from oven circuit breaker harness connecting to main lead wire harness. (blue and yellow housing connectors) 4. Remove 1 screw holding side cover on cavity back plate.