2. To perform automatic adjustment for an adjustment item with the mode number 030 to 047, press P key. If the result of adjustment is OK, the adjustment value changes from flashing to steady on and it is automatically written to EEPROM.
(2) Audio Mode � How to Transfer in the Audio Mode
Mode No. 100 110 111 112 113 114 120 121 *1) 122 *1) 123 *1) 124 *1) 130 131 132 133 134 135 136 137 138 139 140 141 142 143 144 145 146 147 148 Test Description Audio mode Audio playback L/R=1 kHz 0 dB L=1 kHz 0 dB R=1 kHz 0 dB L/R � � dB Audio recording test LINE manual recording MIC manual recording Write Change Description
AUTO ADJ
32 OF
Adjustment value (flashing to steady on)
3. To perform manual adjustment, change the adjustment value with VOLUME EEPROM. + or � key, and press P key to write it to
DEMP LINE manual recording DEMP MIC manual recording Recording VOL HP output LINE automatic recording OPT automatic recording HP VOL HP output MIC automatic recording DEMP LINE automatic recording DEMP OPT automatic recording DEMP MIC automatic recording DIGITAL AGC ADJ1 MIC UP SR MIC DOWN SR MIC THD0 MIC GAIN MIC ATTACK MIC RECOVER MIC THD2 MIC GAIN2 MIC RTIME DIGITAL AGC ADJ2 LINE UP SR LINE DOWN SR LINE THD0 LINE GAIN LINE ATTACK LINE RECOVER LINE THD2 LINE GAIN2 LINE RTIME DIGITAL AGC ADJ3 MAN UP SR MAN DOWN SR AUTO THD3 AUTO LMT UP SR AUTO LMT DOWN SR MAN THD3 MANU LMT UP SR MANU LMT DOWN SR THD1
Note) Normally, automatic adjustment should be performed. Do not execute manual adjustment. � System Gain Mode 1. This mode allows the system gain to be freely adjusted. Press DISPLAY key to enter this mode.
2. Increase or decrease the adjustment value with VOLUME + or � key. 3. Press DISPLAY or p key to return to the normal mode. 4. For the error rate display enabled:
Normal Mode Error rate display System gain Mode Press DISPLAY key
149 150 151 152 153 154 155 156 157 158 159
Cluster value AT error rate BLOCK error rate
000
4F
FF
39 OA
Adjustment value (flashing) Mode No. (lower two digits)
*1) The port is detected and the input is automatically selected. Contents changed : Contents to be changed when VOLUME + or � key is pressed. Write : Mode to permit adjustment (Default value given in parentheses) 1. Go into the test mode. 2. Press + key or VOLUME + key and VOLUME + key in this turn to set the audio mode.
Note) In normal service, do not adjust the system gain mode.
