|
No hay comentarios de productos.
MX-K1
Removing the cassette deck heads (See Fig.21 and 30)
Prior to performing the following procedures, remove the top cover. Also remove the CD changer unit. Also remove the front panel assembly. 1. Remove the five screws "O" that retain the cassette deck mechanism. 2. Remove the cassette deck mechanism and place it so that the front side faces up. 3. Remove the solder from the bottom side of the head terminal and disconnect the wire. 4. Remove the screw "U" that retains the head. 5. Loosen the screw "V" that retains the head. 6. Hold the head and slide it in the direction of the arrow to remove it.
Cassette deck mechanism (Front side)
PB Head
REC/PB Head
V
U
V
U
Fig.30
Removing the 3-pin regulator (See Fig.31 and 32)
Prior to performing the following procedures, remove the top cover. Also remove the rear panel. (See Fig.33) 1. Remove the screw "W" that retains the bracket holding the 3-pin terminal regulator. 2. Remove the solder fixing the 3-pin regulator.
Power amp and supply PCB
Heat sink
W
Fig.31
Power amp and supply PCB
Heat sink
Solder on the 3-pin regulator
Fig.32
1-16
 $4.99 MX-K1 JVC
Manual de Usuario Manual del propietario completo en formato digital. El manual estará disponible para descarga como …
|
