|
|
|
Usuarios conectados
Actualmente hay 6043 visitantes online. |
|
Productos
|
|
Información
|
|
Destacado
|
|
|
 |
|
|
No hay comentarios de productos.
Common Operations
Setting the Clock
Before operating the unit any further, first set the clock built in this unit.
PANEL
Turning On the Power and Selecting the Sources
When you press the play button for a particular source (FM/ AM, CD 6, AUX, and TAPE 2 3), the unit turns on, and the Powered Rolling Panel opens automatically (and the unit starts playing the source if it is ready � COMPU PLAY CONTROL).
TIMER /CLOCK
1 Press PANEL OPEN/CLOSE.
The unit is turned on and the Powered Rolling Panel opens automatically.
OPEN / CLOSE
2 Press TIMER/CLOCK.
To listen to the FM/AM broadcasts, press FM/AM. (See page 12.) To play back CDs, press CD 6. (See pages 13 � 15.) To play back tapes, press TAPE 2 3. (See page 16.) To select the external equipment as the source, press AUX.
FM / AM
CD
The hour digits start flashing on the display.
PRESET
TAPE AUX
3 Press 4 or ¢ to adjust the
hour, then press SET.
To turn on the unit without playing, press POWER so that the STANDBY lamp goes off.
STANDBY
SEA CONTROL SET
� If you want to correct the hour after pressing SET, press CANCEL. The hour digits start flashing again.
POWER
The Powered Rolling Panel opens automatically.
PRESET
4 Press 4 or ¢ to adjust the
minute, then press SET.
SEA CONTROL SET
To turn off the unit (on standby), press POWER again so that the STANDBY lamp lights up. The Powered Rolling Panel also closes. A little power is always consumed even while the unit is on standby.
STANDBY
POWER
To check the clock time
Press DISPLAY while playing any source. � Each time you press the button, the source indication and the clock time alternate on the display.
DISPLAY
To switch off the power supply completely, unplug the AC power cord from the AC outlet.
When you unplug the AC power cord or if a power failure occurs The clock is reset to �AM 12:00� right away, while the tuner preset stations (see page 12) will be erased in a few days.
To adjust the clock again
If you have adjusted the clock before, you need to press TIMER/CLOCK repeatedly until the clock setting mode is selected. � Each time you press the button, the timer/clock setting modes change as follows:
DAILY Canceled ON TIME Clock setting REC ON TIME
(The hour digits start flashing.)
If there is a power failure The clock loses the setting and is reset to �AM 12:00.� You need to set the clock again.
�9�
EN01-12.MX-J50[J]/f 9 99.2.1, 4:06 PM
|
|
|
> |
|
