JVC MX-J206
Manual de Usuario

Listening to FM and AM Broadcasts
Tuning in a Station
On the unit ONLY:

2 Press SET.
SET

1 Press FM/AM.
The unit automatically turns on and tunes in FM /AM the previously tuned station (either FM or AM). (For MX-J300 only, the Powered Rolling Panel automatically opens.) � Each time you press the button, the band alternates between FM and AM.

BASS
SOUND MODE

ST
REC

3 Press PRESET � / + to select a
preset number.

�

PRESET

+

BASS

ST
SOUND MODE REC

2 Press and hold TUNING � / + for
more than 1 second.
The unit starts searching for stations and stops when a station of sufficient signal strength is tuned in.

�

TUNING

+

4 Press SET again.
BASS
SOUND MODE

SET

ST
REC

If a program is broadcast in stereo, the ST (stereo) indicator lights up. To stop during searching, press TUNING � / +.

The tuned station in step 1 is stored in the preset number selected in step 3. � Storing a new station on a used number erases the previously stored one.
When you unplug the AC power cord or if a power failure occurs The preset stations will be erased in a few days. If this happens, preset the stations again.

When you press TUNING � / + briefly and repeatedly The frequency changes step by step.

To change the FM reception mode
When an FM stereo broadcast is hard to receive or noisy, press FM MODE on the remote control so that the MONO indicator lights up on the display. Reception improves.
FM MODE

Tuning in a Preset Station

1 Press FM/AM.
The unit automatically turns on and tunes in FM /AM the previously tuned station (either FM or AM.) (For MX-J300 only, the Powered Rolling Panel automatically opens.) � Each time you press the button, the band alternates between FM and AM.

To restore the stereo effect, press FM MODE again so that the MONO indicator goes off. In this stereo mode, you can hear stereo sounds when a program is broadcast in stereo.

Presetting Stations
You can preset 30 FM and 15 AM stations. In some cases, test frequencies have been already memorized for the tuner since the factory examined the tuner preset function before shipment. This is not a malfunction. You can preset the stations you want into memory by following the presetting method. � There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

2 Select a preset number.
On the unit: Press PRESET � / +. On the remote control: Press the number buttons.
For preset number 5, press 5. For preset number 15, press +10 then 5. For preset number 20, press +10, then 10. For preset number 25, press +10, +10, then 5.

�

PRESET

+

1

2

3

4 7

5 8

6 9

1 Tune in the station you want to preset.
� See �Tuning in a Station� above.
MHz

10

+10

BASS
SOUND MODE

ST
REC

� 14 �

English