|
Usuarios conectados
Actualmente hay 6043 visitantes online.
|
Productos
|
Información
|
Destacado
|
|
|
|
|
No hay comentarios de productos.
MX-GT700
Removing the heat sink & amp. board (See Fig.8, 11 and 12)
Prior to performing the following procedure, remove the metal cover and CD changer unit. 1. Disconnect the card wire from the connector ACW1 and the harness from the connector ACW2, ACW5 and ACW6 on the amp. board. 2. Remove the four screws I attaching the heat sink cover to the rear panel. Remove the heat sink cover. 3. Remove the four screws J attaching the heat sink and two screws K attaching the speaker terminal to the rear panel. 4. After moving the heat sink upward, remove the claws. Then pull out the heat sink & amp. board inward. If the voice board is removed at this time, it will be able to work comfortably.
Heat sink cover
Joint2
(Bottom side)
H
Fig.10
Rear panel
I
I
Removing the fan motor (See Fig.8 and 12)
Prior to performing the following procedure, remove the metal cover and heat sink cover.
1. Disconnect the harness from the connector ACW5 on the amp. board. Fig.11
L J
Rear panel
2. Remove the two screws L attaching the fan motor Claws to the rear panel. Heat sink
M N K
Removing the tuner board (See Fig.12 and 13)
Prior to performing the following procedure, remove the metal cover. 1. Disconnect the card wire from the connector CON01 on the tuner board. 2. Remove the two screws M attaching the tuner board to the rear panel.
J
Speaker terminal
O P
Fig.12
Main board CON01 Rear panel
Tuner board
Removing the rear panel
(See Fig.12)
Prior to performing the following procedure, remove the metal cover, CD changer unit, heat sink & amp. board and tuner board. 1. Remove the two screws N, screw O and three screws P attaching the rear panel.
Fig.13
1-7
|
|
|
> |
|