|
No hay comentarios de productos.
3.1.5 Removing the heat sink & amp. Board (See Fig. 8, 11 and 12) � Prior to performing the following procedure, remove the metal cover and CD changer unit. (1) Disconnect the card wire from the connector ACW1 and the harness from the connector ACW2 on the amp. board. (2) Remove the four screws I attaching the heat sink cover to the rear panel. Remove the heat sink cover. (3) Remove the four screws J attaching the heat sink and two screws K attaching the speaker terminal to the rear panel. (4) After moving the heat sink upward, remove the claws. Then pull out the heat sink & amp. board inward. 3.1.6 Removing the tuner board (See Fig. 12 and 13) � Prior to performing the following procedure, remove the metal cover. (1) Disconnect the card wire from the connector CON01 on the tuner board. (2) Remove the two screws L attaching the tuner board to the rear panel. 3.1.7 Removing the rear panel (See Fig. 12) � Prior to performing the following procedure, remove the metal cover, CD changer unit, heat sink & amp. board and tuner board. (1) Remove the screw M and three screws N attaching the rear panel.
Rear panel
I
Heat sink cover
I
Fig.11
Rear panel
J
Claws Heat sink
L K M
Speaker terminal
J
N
Fig.12
CON01 Main board Rear panel
Tuner board
Fig.13
(No.MB080)1-9
|
