JVC MX-DVA9R
Manual de Usuario

Common Operations
Turning On or Off the Power
To turn on the unit, press STANDBY/ON so that the STANDBY lamp goes off.
STANDBY/ON STANDBY

To check the clock time
Press and hold SET while playing any source. � Pressing SET, the source indication appears again.

To adjust the clock again
If you have adjusted the clock before, you need to press CLOCK/TIMER repeatedly until the clock setting mode is selected. � Each time you press the button, the clock/timer setting modes change as follows:
DAILY Canceled ON TIME
(Daily timer setting)

To turn off the unit (on standby), press STANDBY/ON again so that the STANDBY lamp lights up.

STANDBY/ON STANDBY

REC ON TIME
(Recording timer setting)

Clock setting
(The hour digits start flashing.)

� A little power is always consumed even while the unit is on standby. To switch off the power supply completely, unplug the AC power cord from the AC outlet.
When you unplug the AC power cord or if a power failure occurs The clock is reset to �0:00� right away, while the tuner preset stations (see page 15) will be erased in a few days.

When you unplug the AC power cord or if a power failure occurs The clock is reset to �0:00� right away. If this happens, set the clock again.

Setting the AM Tuner Interval Spacing
Some countries space AM stations 9 kHz apart, and some countries use 10 kHz spacing.

Setting the Clock
Before operating the unit any further, first set the clock built in this unit. You can set the clock whether the unit is on or off.

On the unit ONLY:
When shipped, the unit is set to 9 kHz spacing. You can only change the AM tuner interval spacing while tuning into an AM station. (See page 15.) Press STANDBY/ON while holding down 7. � Each time you press these buttons, the AM tuner interval spacing alternates between 9 kHz and 10 kHz.
STANDBY/ON

On the unit ONLY:

1 Press CLOCK/TIMER.
The hour digits start flashing on the display.

2 Turn 4 / ¢ to adjust the
hour, then press SET.
The minute digits start flashing on the display.

STANDBY

� If you want to correct the hour after pressing SET, press CANCEL/DEMO. The hour digits start flashing again.

3 Turn 4 / ¢ to adjust the minute, then
press SET.

� 11 �