PHILIPS MX1060D
Manual de Servicio

9A-1

9A-1

SERVICING THE DVD MODULE
The only service parts available for replacement are: DVD Main Board (STi5519) ........................ 9965 000 12052 DVD Mechanical Loader TVM502T ........... 9965 000 10185

Reprogramming of the DVD Main Board

DVD MODULE
(For Information Only)

Caution: This information is confidential and may not be distributed. Only a qualified service person should reprogram the DVD Main Board.
After replacement of the DVD Main Board, the customer settings and also the region code will be lost. Reprogramming of the DVD Main Board will put the player back in the state in which it has left the factory, ie. with the default settings and the allowed region code

It is not recommended for component repair on this Module but to replace the major assembly when it becomes defective. Therefore no service parts list are published in this Chapter. The Circuit & Layout diagrams are published for reference only. The repair assistance on DVD section is given on Chapter 2.

Reprogramming is done by way of the Remote Control as given below: Message displayed on TV screen 1. With the unit on and no disc in the tray press DVD key 2. Press Menu key Setup Menu is displayed 3. Press numerical keys <1> <6> <7> "Key 1 - 6 for Region: is displayed 4. Press any one numerical keys between <1> and <6> as per Region codes given in the table below Selected region code is displayed 5. Press Exit key.

Type/version MX1015D/37 MX1050D/22 MX1055D/37S MX1060D/22S

Destination USA Europe USA Europe

Region Code* 1 2 1 2

* Note: The Region code may differs in some countries, in such case the Region code of the country should be used.

Upgrading of DVD software by way of an Upgrade Disc and Remote Control as given below: Message displayed on TV screen 1. With the unit on and no disc in the tray press DVD key 2. Press Eject key to open the tray 3. Press Menu key Setup Menu is displayed 4. Press numerical keys <7> <6> <0> "Update Software 1/Yes, 2/No" is displayed 5. Press numerical keys <1> "Yes" is displayed briefly after which the message disappear 6. Insert upgrade disc and press Eject key to close tray 7. The set starts reading upgrade disc "Color bars" is displayed when ready 8. Press Power key to bring the set into Standby mode. 9. Remove the upgrade disc by power-up the set & eject to open tray.