The Display will show what you touched. This example shows you touched Number Pad 5 for 50% of full power. 5. Touch a Number pad for the Cook Power you want.
6. Touch START.
The AUTO SET Indicator Light will stay on while the oven is cooking in the preprogrammed cycle. If you selected a Cook Power other than high, the Cook Power Signal Light will also come on. This shows you the oven is cooking at a selected Cook Power.
d
COdI OWll
The Display counts down the time to show how much cooking time is left.
For 2 of every 10 seconds, the Display will show the Cook Power you selected, if you are using a Cook Power other than high. When Auto Set ends, �End� will show on the Display and 4 beeps will sound. (You can stop the beeping by opening the door or by touching CANCEL.) �End� will remain on the Display and a beep will sound every 30 seconds (to remind you that food is left in the oven) until the door is opened or CANCEL is touched. The Display will then show the time of day.
You can set COOK to follow Auto Set TIME, if desired. Touch in instructions for�Cooking your microwave oven:� page 8; or �Cooking at lower cook powers:� page 9.
in
Changing
the pre-programmed
setting
You can change the pre-programmed cooking time and Cook Power in AUTO SETTIME to the time and power you most often use. To change the AUTO SETTIME setting, follow these steps. 1. Place food in the oven and close the door. 2. Touch TIME twice. 3. Touch the Number Pads for the new desired cooking time. If high Cook Power is desired, skip to Step 6. 4. Touch COOK POWER. 5. Touch the Number Pad forthe desired Cook Power. 6. Touch START.The oven will cook at the new cooking time and Cook Power you selected. After the cooking is complete, the oven will remember that time and Cook Power for future use. NOTE: If the electric power ever goes off, the oven will go back to the pre-programmed 2 minutes, 30 seconds at high Cook Power setting.