ZOOM MRS-1608
Manual de Usuario

Reference [Effects]

4.

To change the effect type, turn the dial.

When the effect type is changed, the effect parameters will also change accordingly.

NOTE
Keep in mind that if you select another patch without �rst storing the edited patch, the changes will be lost. To keep the results of your editing session, refer to the following section.

TYPE DELAY
HINT
If the contents of a patch have been changed, the �EDIT� indicator in the upper part of the display will change to �EDITED�. When the setting is returned to the original condition, the indicator reverts to �EDIT�.

Storing/swapping send/return effect patches
A patch that you have edited can be stored in any location of the same send/return effect. You can also store an existing patch in another location to create a copy of that patch. Interchanging the position of patches (swapping) is also possible.

5.

Use the cursor up/down keys to select the effect parameter that you want to edit.

1.

At the send/return effect patch select screen, press the [STORE] key.

The �rst line of the display shows the effect type, and the second line shows the name and current value of the effect parameter.

The currently selected patch goes into the store standby condition. In this condition, you can perform the store or swap operation.

DELAY TIME
Effect parameter

370
Setting value

STORE TO DeepCho No.7
Patch number

HINT
To change the effect type, repeatedly press the cursor up key to display the effect type name, and then turn the dial.

2. 3. 4.

Use the cursor left/right keys to bring up the indication �STORE TO� or �SWAP TO�. Turn the dial to select the number of the patch to store/swap.

6.

Turn the dial to change the setting.

For details on the effect types that can be selected for reverb or chorus/delay, and on the range of each effect parameter, refer to the appendix at the end of this manual.

To carry out the store/swap operation, press the [STORE] key.

7. 8.

Repeat steps 5 � 6 as necessary to edit other effect parameters. When you have �nished editing, press the [EXIT] key.

When the store/swap operation is completed, the send/return effect patch select screen appears again.

� Patches that you have stored are saved on the hard disk as part of the project. � Patch data included in an already existing project can be loaded into the current project (� p. 149).

HINT

The send/return effect patch select screen appears again.

148

ZOOM MRS-1608