|
Usuarios conectados
Actualmente hay 6005 visitantes online.
|
Productos
|
Información
|
Destacado
|
|
|
|
|
No hay comentarios de productos.
Surface
Cooktop
Cooking
(continued)....,,.,........,,..,.....,.,. Burner Grates
The grates must be prop- E',,_) _.--.-../AI Ir-."..-_ f_¢'/_"_ erly positioned before /__ ff _J[ 1{ _%_ "_ ___-'_\ cooking. Improperin- /_ r_ _[ [_ n _-_\ stallationofthegrates L__.___ [__1 may result in chip- '_:'_ ping of the cooktop, dependingnmodel. o Do not operate the burners without a pan on the grate. The grate's porcelain finish may chip without a pan to absorb the heat from the burner flame. Although the burner gratesGrate durable, they will gradually are design may differ slightly lose their shine and/or discolor, due to the high temperatures of the gas flame.
To prevent the cooktop from discoloring or staining: � Clean cooktop after each use. ' Wipe acid or sugar spills as soon as the cooktop has cooled as these spills may discolor the porcelain,
Unlike a range with standard gas burners, this cooktop does not lift-up nor is it removable. Do not attempt to lift the cooktop for any reason.
SealedBurners
The sealed burners of your range are secured to the cooktop and are not designed to be removed. Since the burners are sealed into the cooktop, believers or spills will not seep underneath the cooktop. However, the burner heads should be cleaned after each use. (See page 16-17 for cleaning directions.) ) On select models the burner head portion of the sealed burner has a removable cap that is easily removed for cleaning. The burner will operate effectively withorwithouttheburnercap, High Performance Burners (12,000 BTU*) There are one or two high speed burners on your range, depending upon the POWER II _ 11111 model, rhey are located in the left rear BOOST and/or right front positions. Power I[[[][I I[[[[[I boost burners offer higher speed cook",u, ',w ing that can be used to quickly bring water to a boil and for large-quantity cooking, � BTU ratings will vary when using LP gas.
NOTES
�..
� A properly adjusted burner with clean ports will light within a few seconds. If using natural gas the flame will be blue with a deeper blue inner cone. If the burner flame is yellow or is noisy the air/gas mixture may be incorrect. Contact a service technician ranty.) to adjust. (adjustments are not covered by the warWith LP gas, some yellow tips on the flames are acceptable. This is normal and adjustment is not necessary. � With some types of gas, you may hear a "popping" sound when the surface burner is turned off. This is a normal operating sound of the burner. ° If the control knob is turned very quickly from HIGH to LOW, the flame may go out, particularly if the burner is cold. If this occurs, turn the knob to the OFF position, wait several seconds and relight the burner. ' Refer to page 20 to adjust the LOW setting, if needed.
:'
....
i ) :_ if!! !;:_!! ? ;
' The flame should be adjusted so it does not extend beyond the edge of the pan.
ii
? i
-
_
i
!;Z_!
i
?:; i?i
9
|
|
|
> |
|