WHIRLPOOL MGC5430ADW
Manual de Usuario

!_!il

Sealed Burners
The sealed burners of your cooktop are secured to the cooktop and are not designed to be removed. Since the burners are sealed into the cooktop, believers or spills will not seep underneath the cooktop. The cooktop does not lift up. However, the burner heads should be cleaned after each use. The head portion of the burner has a removable cap that is easily removed for cleaning. (See page 8 for cleaning directions.) The burner will operate effectively with or without the burner cap.

NOTES...
, A properly adjusted burner with clean ports will light within a few seconds. If using natural gas the flame will be blue with a deeper blue inner cone. If the burner flame is yellow or is noisy the air/gas mixture may be incorrect. Contact a service technician to adjust. (Adjustments are not covered by the warranty.) With LP gas, some yellow tips on the flames are acceptable. This is normal and adjustment is not necessary. � With some types of gas, you may hear a "popping" sound when the surface burner is turned off. This is a normal operating sound of the burner. � If the control knob is turned very quickly from HIGH to LOW, cold. flame may go turn the knob to theif the burner is the If this occurs, out, particularly OFF position, walt several seconds and relight the burner. ° Refer to page 7 to adjust the Low setting, if needed. U@I � The flame should be adjusted so it does not extend beyond the edge of the pan.

High Performance Burner
(12,000 BTU*, select models) There is one high speed burner on your cooktop located in the right front position. This burner offers higher speed f----'l cooking thatlarge-quantitytocooking, bring water to a POWER ___(_ boil and for can be used quickly BOOST Simmer Burner (850 BTU* - select models) Select cooktop models offer one simmer burner. This burner is locatedalower right rear position. The simmer burner offers in the BTU flame for delicate

L__J
SIMMER

� BTU ratings will vary when sauces or melting chocolate. using LP gas.

_

_

_

The grates must be properly positioned before cooking. Improper installation of the grates may result in chipping of the cooktop. Do not operate the burners without a pan on the grate. The grate's porcelain finish may chip without a pan to absorb the heat from the burner flame. Although the burner grates are durable, they will gradually lose their shine and/or discolor, due to the high temperatures of the gas flame,

Burner Grates

Operating During a Power Failure
1. Hold a lighted match to the desired surface burner head. 2. Push in and turn the control knob slowly to LIGHT. 3. Adjust the flame to the desired level. ACAUTION: When lighting the surface burners, be

sure all of the controls are in the OFF position. Strike the match first and hold it in position before turning the knob to LIGHT.

6