|
Usuarios conectados
Actualmente hay 5608 visitantes online.
|
Productos
|
Información
|
Destacado
|
|
|
|
|
No hay comentarios de productos.
Contents
Connecting the Units ................................ 1 Installation .................................................. 5
DIN Front/Rear-mount ...................................... 5 DIN Front-mount .............................................. 5 - Installation with the rubber bush - Removing the Unit DIN Rear-mount ................................................ 7 - Installation using the screw holes on the side of the unit
Connecting the Units
Note:
â�¢ This unit is for vehicles with a 12-volt battery and negative grounding. Before installing it in a recreational vehicle, truck, or bus, check the battery voltage. â�¢ To avoid shorts in the electrical system, be sure to disconnect the â� battery cable before beginning installation. â�¢ Refer to the ownerâ��s manual for details on connecting the power amp and other units, then make connections correctly. â�¢ Secure the wiring with cable clamps or adhesive tape. To protect the wiring, wrap adhesive tape around them where they lie against metal parts. â�¢ Route and secure all wiring so it cannot touch any moving parts, such as the gear shift, handbrake, and seat rails. Do not route wiring in places that get hot, such as near the heater outlet. If the insulation of the wiring melts or gets torn, there is a danger of the wiring short-circuiting to the vehicle body. â�¢ Donâ��t pass the yellow lead through a hole into the engine compartment to connect to the battery. This will damage the lead insulation and cause a very dangerous short. â�¢ Do not shorten any leads. If you do, the protection circuit may fail to work when it should. â�¢ Never feed power to other equipment by cutting the insulation of the power supply lead of the unit and tapping into the lead. The current capacity of the lead will be exceeded, causing overheating. â�¢ When replacing fuse, be sure to use only fuse of the rating prescribed on the fuse holder. â�¢ Since a unique BPTL circuit is employed, never wire so the speaker leads are directly grounded or the left and right â� speaker leads are common. â�¢ The black lead is the ground. Please ground this lead separately from the ground of high-current products such as power amps. If you ground the products together and the ground becomes detached, there is a risk of damage to the products or fire.
1
|
|
|
> |
|