SHARP MDX8
Manual de Usuario

(Continued) H Listening to stereo turntable
AUX

REC
MD

1 2 3 4 5

Connect the output cables of the stereo turntable to the PHONO jack . (red right channnel, white left channel) Press the POWER button to turn the power on. Press the AUX button so that the PHONO display appears. Start the stereo turntable. Start recording with this unit, and perform steps 2-5 of the "Recording from the built-in radio onto a MiniDisc" procedure. (See page 29.)

VOLUME
DOWN UP

Note: I The turntable must be outfitted with a magnetic type cartridge.
MIC VOL

H Using the microphone
You can record voices from the microphone to an MD or enjoy singing karaoke to the accompaniment of the playback sound from this product. (Mic mixing)

H Using the microphone as a loudspeaker
MD
REC AUX

1

Plug the microphone into the MIC jack.

I Set the MIC VOL control to the minimum position.

2 Speak into the microphone. 3 Adjust the volume using the MIC VOL control and the VOLUME
control. To record sound from the microphone:

4 5 6 7

Load a recordable MiniDisc. Press the AUX button so that the AUX 1 AUX 2 display appears. Press the REC button. Press the MD 06 button.

I The sound from the microphone will be mono. (When using a stereo microphone, only the left channel will be effective.) I If the volume of the MIC VOL control is set too high, feedback may occur. If this happens, take one or more of the following steps. · Decrease the MIC VOL control level. · Keep the microphone away from the speaker. · Change the orientation of the microphone. · Turn down the volume.

H Mixing with music
Notes: I When not using the microphone, make sure to unplug it. Otherwise undesirable sounds may be heard, or recorded. I When plugging in or unplugging the microphone, set the MIC VOL control to the minimum position. I It is possible to record sound from an external analog source connected to the MD IN/AUX 1 or AUX 2 input terminals, mixed together with sound from the microphone. However, when an external digital unit is connected to the AUX DIGITAL IN terminal, the sound picked up by the microphone will not be recorded on the MD, even though it can be heard through the speakers.

1 2 3 4

Plug the microphone into the MIC jack. Speak into the microphone. Adjust the microphone level using the MIC VOL control. Select the sound source you want to play, and start playback.

I Set the MIC VOL control to the minimum position.

To make a mixed recording:

1 2 3 4

Load a recordable MiniDisc. Perform steps 1-4 above. Press the REC button. Press the MD 06 button.

I Make sure to connect the microphone first. If it is connected later, it will not be possible to make a mixed recording.

48
38-58 48 98.6.23, 10:34 AM