Hooking up the audio component (continued)s To connect a PC
E PC connecting kit (not supplied)
Use the PC connecting kit to connect a PC to the MD deck. By connecting the MD deck to a PC, you will be able to select and play MD tracks and do various editing operations on the PC. For details, refer to the manual supplied with the PC connecting kit.
Tip
Demonstration mode
When you turn on the MD deck and there is no MD in the deck, demonstration mode is activated automatically after about ten minutes. To deactivate demonstration mode, press any button on the deck or on the remote.
Tip
You can connect a PC to the PC LINK (KEYBOARD) connector on the front panel of the MDS-JE770.
To turn off demonstration mode, press x and CLEAR simultaneously when there is no MD in the deck. �Demo Off� appears in the display. To turn on demonstration mode again, perform the same procedure described above. �Demo On� appears in the display.
To connect the AC power cord
Connect the AC power cord of the deck to a wall outlet.
Note
If you use a timer, connect the AC power cord to the outlet of the timer.
Inserting batteries into the remote
Insert two R6 (size-AA) batteries into the battery compartment with the + and � properly oriented to the markings. When using the remote, point it at the remote sensor on the deck.
Tip
When the remote no longer operates the deck, replace both batteries with new ones.
Notes
� Do not leave the remote in an extremely hot or humid place. � Do not drop any foreign object into the remote casing, particularly when replacing the batteries. � Do not use a new battery with an old one. � Do not expose the remote sensor to direct sunlight or lighting apparatus. Doing so may cause a malfunction. � If you don�t use the remote for an extended period of time, remove the batteries to avoid possible damage from battery leakage and corrosion.
