SHARP MDMS702HBL
Manual de Servicio

ERROR MESSAGES

Error messages Meaning Remedy the AC adaptor for power). disc.

The run down. Charge the rechargeable battery or

BATT EMPTY replace the alkaline batteries (or use

Nothing is recorded. Replace the disc with a recorded BLANK DISC

No copy can be made because of Record using the analogue cable. Can't COPY the SCMS copyright system. A track cannot be edited. Change stop position of the Can't EDIT track and then try editing it.

Recording cannot be performed Re-record or replace it with another

Can't REC correctly due to vibration or shock recordable disc.

in the unit.

Can't WRITE Editing is impossible. Check the number of tracks. try recording again. DEFECT Replace the disc with another recordable disc.

The disc scratched. If the sound you hear is not right,

Din UNLOCK Poor connection of cable. Connect the digital cable securely. DISC ERROR The is damaged. Reload the disc or replace it. disc. original position.

The disc is out of recording space. Replace it with another recordable DISC FULL

The unit is in safety mode. Return the HOLD switch to its HOLD

�7�
sources. unit. while.

LOCKED The EJECT lever was moved Turn off power and remove the LOCK ERROR during recording or editing. MiniDisc. NO DISC A disc has not been loaded. Load a disc.

PROTECTED only Replace it with a recordable disc.

The disc is protected. Move the write protection knob PB DISC You tried record on a playbackback to its original position.

Improper is being supplied. Use one of the specified power POWER ?

Since track number is currently Wait for a while and try the

SORRY being located or written to, the unit operation again.

cannot accept your command. You come conclusion To have it repaired, go to the

SYSTEM ERR that unit is out of order. distributor where you purchased the

The temperature is too high. Turn off the power, and wait for a TEMP OVER

A large portion of the disc has been Replace it with another recorded TOC ERROR damaged. disc. There is no space left for recording Replace it with another recordable

TOC FULL character information (track names, disc.

MD-MS701H/MS702H

Tr. Protect

disc names, etc.). The has been protected from Edit track with the device on being erased. which it was recorded. A large portion of the disc has been Replace it with another recorded damaged. disc. U TOC ERROR There is an error in recorded Erase all of the signal errors, and signal. then try recording again. data other A disc which contains non-music than music was data cannot be played. ? DISC There is an error in the signal from Replace it with another recorded the disc.