DISASSEMBLY INSTRUCTIONS
1-5: FRONT TRAY PLATE/TOP SHIELD (Refer to Fig. 1-5) 1. Unlock the 2 supports 1. 2. Remove the Front Tray Plate in the direction of arrow (A). 3. Remove the 12 screws 2. 4. Remove the Top Shield in the direction of arrow (B).
2 2 2 2 2 2 2 2 3
DVD PCB DVD Deck
2 2 2
Pick Up PCB
2
Make the sort circuit using a soldering.
2
(B)
3
3
3
Top Shield
1 1
(C)
2
(B)
2 2
1
1
Angle Deck
Front Tray Plate
1 1
(A) (A)
DVD Block
Fig. 1-5 1-6: DVD PCB/DVD DECK (Refer to Fig. 1-6) 1. Make the short circuit on the position as shown Fig. 1-6 using a soldering. If you remove the DVD Deck with no soldering, the Laser may be damaged. 2. Disconnect the following connectors: (CP8001 and CP8002). 3. Remove the 4 screws 1. 4. Remove the Angle Deck in the direction of arrow (A). 5. Disconnect the following connectors: (CP2001, CP2301 and CP2302). 6. Remove the 4 screws 2. 7. Remove the DVD Deck in the direction of arrow (B). 8. Remove the 4 screws 3. 9. Remove the DVD PCB in the direction of arrow (C). NOTE When the installation of the DVD Deck, remove all the soldering on the short circuit position after the connection of Pick Up PCB and DVD PCB connector.
AV PCB
Fig. 1-6 1-7: AV PCB (Refer to Fig. 1-7) 1. 2. 3. 4. Remove the screw 1. Remove the screw 1. Remove the AV Jack Shield. Remove the AV PCB in the direction of arrow.
