HOSE REPLACEMENT
Removal
1. Remove the dust cover and dust bag. 2. Remove the end of the hose from the wand. Remove the hose by removing the two screws which secure it to the dust container.
EXPLODED VIEW (NOZZLE HOUSING)�
A BLOCK
A-14 A-3
Replacement
1. Install the new hose by replacing the two screws which secure it to the dust container.
A-1
A-6 A-15
A-7
2. Replace the hose onto the wand. 3. Replace the dust bag and dust cover.
A-2
MOTOR PROTECTOR REPLACEMENT
Removal
1. Remove the dust cover and dust bag. 2. Remove the motor protector (shown in the exploded view in the C Block section), by pushing in, one at a time, on the tabs that secure it to the dust compartment. Push the motor protector out the back of the dust compartment. 3. Once the motor protector is out it can be disassembled for parts replacement.
A-5
Disassembly
1. Holding a pair of needle nose pliers at an angle and in a position where one side of the pliers is against the locking tab, exert enough pressure on the tab to release it (Fig. 11). NOTE: There are two locking tabs present, but only one needs to be released. For reassembly look at the exploded view in the C Block.
A-4
B BLOCK
Installation
(Fig. 11)
1. Reinstall the motor protector into the dust compartment by aligning the two tabs under the top flange with the slots in the dust compartment and applying pressure until it snaps into place.