4. Slide P.C.B. out off slots in handle cover unit to expose two screws holding switch support in place. 5. Remove two (2) screws from switch support. 6. Disconnect lead wires from switch and remove defective switch.
3.4.2.
Installation
1. Reconnect lead wires to switch. 2. Reinstall switch support into handle cover unit. 3. Reinstall P.C.B into slot in handle cover unit. 4. Reinstall handle plate on motor unit into handle cover unit and secure with two (2) screws. 5. Position handle cover unit into body. 6. Reinstall dust cover and secure with six (6) screws. 7. Reinstall motor case and secure with six (6) screws.