6. Check to see that the belt is centered in the belt groove. 7. Rotate the agitator assembly by hand to insure nothing rubs and check for correct assembly.
3.4.
3.4.1.
Headlight Bulb Replacement
Removal
8. Replace the lower plate as outlined in the Lower Plate Replacement section.
1. Disconnect power cord from electrical outlet. Lower body to lay vacuum cleaner flat. 2. Pry out light lens at slots by inserting screwdriver into slot, pushing down on the lens and rotating the screwdriver handle toward unit. 3. Remove the light bulb by pulling straight out.
3.3.
3.3.1.
Belt Replacement
Removal
1. Remove the lower plate. 2. Remove the agitator assembly. 3. Remove old / damage belt.
3.4.2.
Installation
1. To replace the light bulb carefully insert securely into slot. 2. Replace lens cover by inserting bottom tab of lens into slot then applying pressure to top tabs with a screwdriver. 3. A �popping� sound indicates lens is snapped properly in place.
3.3.2.
Installation
1. Place the new belt around the motor shaft.
3.5.
3.5.1.
Handle Assembly Replacement
Removal
1. With the handle on its lowest position, depress the handle height adjustment button and raise handle about 6 cm while turning it counterclockwise. 2. You should be able to turn the handle 90° to a transversal position.
2. Install the agitator assembly. 3. Install the lower plate.
3. Pull handle straight out until free from vacuum cleaner.