Using the remote control
IMPORTANT! � Remove the protective plastic tab before using the remote control.
Setting the clock
After connecting MCM275 to the power supply, set the clock first.
1 In the standby mode, press and hold DISPLAY/
CLOCK on the remote control � SET CLOCK scrolls on the display � 24 HR or 12 HR appears for the initial clock setting. To select 24-hour clock or 12-hour clock, � On the remote control, press VOLUME +/once or more (or turn VOLUME on the set) � On the remote control, press DISPLAY/ CLOCK to confirm � The hours digits start flashing Hold down or press VOLUME +/- repeatedly to set the hours (or turn VOLUME on the set) Press DISPLAY/CLOCK to confirm � The minutes digits start flashing Hold down or press VOLUME +/- repeatedly to set the minutes (or turn VOLUME on the set) Press DISPLAY/CLOCK to confirm � To exit without storing the clock setting press STOP 9 Helpful hints: � The clock setting will be erased when the system is disconnected from the power supply. � The set will exit from the clock setting mode if no button is pressed within 90 seconds.
� Always point the remote control directly towards IR area. Notes for remote control: � First select the source you wish to control by pressing one of the source select keys on the remote control (for example CD,TUNER). � Then select the desired function (for example ��, 4 , ¢). To replace the remote controls� battery
â�
2 3 4 5
1 2 3 4
Press and hold 1 as indicated Simultaneously, pull the battery tray at 4 Remove the old battery and put a new CR2025 battery in place Put back the battery tray
2 1 3
CR 202
/
5
T H IU M
CAUTION! � Remove the battery if it is exhausted or will not be used for a long time. � Batteries contain chemical substances, so they should be disposed of properly.
