Basic Functions
To exit without storing the Plug and Play
MICRO SYSTEM MCM204
� Press 9 on the system. � If you do not complete the Plug and Play installation, the function will be restarted when you next turn on the main supply again. Notes: � If no stereo frequency is detected during Plug and Play, "CHECK ANTENNA" will be displayed. � During Plug and Play, if no button is pressed within 15 seconds, the system will exit Plug and Play mode.
ALBUM/
IMPORTANT: Before you operate the system, complete the preparation procedures.
Plug and Play (for tuner installlation)
Plug and Play allows you to store all available radio stations automatically. First time setup/power up
1 2
When you turn on the main supply, "AUTO INSTALL - PRESS PLAY" is displayed. Press �� on the system to start installation. � "PLUG AND PLAY" .... "INSTALL" is displayed, followed by "TUNER" and "AUTO". � PROG starts flashing. � The system will automatically store the radio stations with sufficient signal strength, starting from FM, and followed by MW band. � When all the available radio stations are stored or the memory for 40 presets are used, the last preset radio station will be played. To reinstall Plug and Play
1 2
In standby mode, press and hold�� on the system until "AUTO INSTALL - PRESS PLAY" is displayed. Press �� again to start installation. � All previously stored radio stations will be replaced.
