Troubleshooting
WARNING Under no circumstances should you try to repair the system yourself, as this will invalidate the warranty. Do not open the system as there is a risk of electric shock. If a fault occurs, first check the points listed below before taking the system for repair. If you are unable to remedy a problem by following these hints, consult your dealer or Philips for help. Problem Radio reception is poor. Solution � If the signal is too weak, adjust the antenna or connect an external antenna for better reception. � Increase the distance between the system and your TV or VCR. � Insert a disc. � Load in the disc with label facing up. � Replace or clean the disc, see �Care and safety information�. � Use a finalised CD-R(W) or a correct format disc. � Remove and reconnect the AC power cord and switch on the system again. � Use only NORMAL (IEC I) tape. � Apply a piece of adhesive tape over the missing tab space. � Remove and reconnect the AC power plug and switch on the system again. � � � � Adjust the volume. Disconnect the headphones. Check that the speakers are connected correctly. Check that the AC power cord is connected properly.
E n g l i s h
�NO DISC� is displayed or the disc cannot be played.
The system does not react when buttons are pressed. Recording or playback cannot be made.
The tape deck door cannot open.
Sound cannot be heard or is of poor quality.
The remote control does not function properly.
� Select the source (CD or TUNER, for example) before pressing the function button (� , � S, T). � Reduce the distance between the remote control and the system. � Replace the battery. � Point the remote control directly toward the IR sensor. � Set the clock correctly. � Press TIMER ON /OFF to switch on the timer. � If recording is in progress, stop the recording. � Press and hold DEMO STOP on the main unit to switch off the demonstration mode.
The timer is not working.
The system displays features automatically and buttons start flashing.
