PHILIPS MCM108D/98
Manual de Usuario

General Information
IMPORTANT! PLEASE NOTE THAT THE VOLTAGE SELECTOR LOCATED AT THE REAR OF THIS SYSTEM IS PRESET AT 220V FROM THE FACTORY. FOR COUNTRIES THAT OPERATE AT 110V-127V, PLEASE ADJUST TO 110V-127V BEFORE YOU SWITCH ON THE SYSTEM.

Safety Information
� Before operating the system, check that the operating voltage indicated on the typeplate (or the voltage indication beside the voltage selector) of your system is identical with the voltage of your local power supply. If not, please consult your dealer. � Place the system on a flat, hard and stable surface. � The apparatus shall not be exposed to dripping or splashing. � Install the unit near the AC outlet and where the AC power plug can be easily reached. � Place the system in a location with adequate ventilation to prevent internal heat build-up in your system. Allow at least 10 cm (4 inches) clearance from the rear and the top of the unit and 5 cm (2 inches) from each side. � The ventilation should not be impeded by covering the ventilation openings with items, such as newspapers, table-cloths, curtains, etc. � Do not expose the system, batteries or discs to excessive moisture, rain, sand or heat sources caused by heating equipment or direct sunlight. � No naked flame sources, such as lighted candles, should be placed on the apparatus. � No objects filled with liquids, such as vases, shall be placed on the apparatus. � If the system is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lens of the disc unit inside the system. Should this occur, the CD player would not operate normally. Leave the power on for about one hour with no disc in the system until normal playback is possible. � The mechanical parts of the set contain selflubricating bearings and must not be oiled or lubricated. � When the system is switched to Standby mode, it is still consuming some power. To disconnect the system from the power supply completely, remove the AC power plug from the wall socket.

Supplied accessories
� � � � 2 speaker boxes MCM108D remote control with battery MW loop antenna Docking kit - 1 Apple iPod dock and 1 Philips GoGear jukebox dock - Dock adaptors (8 adaptors for different iPod types, and 4 adaptors for different Philips GoGear types) - 1 Docking cable

Environmental Information
All unnecessary packaging has been omitted. We have tried to make the packaging easy to separate into three materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet). Your system consists of materials which can be recycled and reused if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packaging materials, exhausted batteries and old equipment.

3