1. Place handle in low position. 2. Turn the vacuum cleaner over exposing the underside. Release the lower plate by pressing the two (2) latches that secure it inward. 3. Separate the lower plate from the vacuum.
2. Remove the lower plate as outline in Lower Plate remove / installation section.
3.1.2.
place.
Installation
3. Carefully lift up on the agitator assembly until it clear both sides of the nozzle housing.
1. Hook the front of the lower plate into the slots on the front of the nozzle housing. Press the lower plate down into 2. Fasten the lower plate by pushing the two (2) latches outward. NOTE: For general servicing, it is necessary to eliminate pinching of any wire during reassembly. After servicing any electrical component or enclosure, the unit should be reassembled and checked for dielectric breakdown or current leakage.
3.2.
3.2.1.
Agitator Assembly
Removal
4. Remove the belt from the motor shaft by sliding it off between the end of the shaft and the nozzle housing.
1. The brushes are not replaceable separately. When the brushes need replacing, the agitator assembly will have to be replaced.
