Tape Operation / Recording
Switching tape sides
The tape side can be switched manually or automatically before or during tape playback. G Press DISPLAY BAND or A/B on remote control. � The display shows SIDE A or SIDE B.
E n g l i s h
Reverse mode options
G Press PROG / REV repeatedly to select your option; PLAY 1 SIDE : playback or record stops at the end of the tape. PLAY A AND B : both sides are or recorded played once. REPEAT A AND B : both sides are played repeatedly, up to 5 times each side.
Tape playback 1 2 3
Select TAPE source. Press to open the tape door on the top of the system.
General information on recording
G Recording is permissible insofar as copyright or other rights of third parties are not infringed. G For recording, use only NORMAL (IEC type I) tapes on which the tabs have not yet been broken. This deck is not suited for recording on METAL (IEC IV) type tapes. G The best recording level is set automatically. Altering the VOLUME, INCREDIBLE SURROUND, DBB or INTERACTIVE SOUND controls will not affect the recording in progress. G At the very beginning and end of the tape, no recording will take place during the 7 seconds when the leader tape passes the recorder heads. G To protect a tape from accidental erasure, have the tape in front of you and break out the left tab. Recording on this side is no longer possible. If, however, you wish to record over this side again, cover the tabs with a piece of adhesive tape.
Insert a recorded tape and close the tape door. G Load the tape with the open side downward and the full spool to the right. � The display shows TAPE briefly. The tape counter 0000 display with the SIDE A or SIDE B. Press to start playback.
4 5
By pressing or , fast winding of tape is possible in both directions. G During fast winding, you can monitor the tape message with the tape counter.
6
To stop the tape, press STOP 9 . G To reset the tape counter, press STOP 9 again. Note: � The sound source cannot be changed while recording a tape. � �NO TAPE� will be shown if no tape inserted.
