PHILIPS MC-30/25
Manual de Usuario

Tape Recorder
English
STANDBY-ON
iR

Switching tape sides
The tape side can be switched manually or automatically before or during tape playback. ¶ Press SIDE A/B (SIDE/; or during playback only 2 on the remote control). � The display shows A or B and the tape counter resets to 000. Reverse mode options ¶ Press REV MODE once or more to select your option; å : playback stops at the end of the tape. � : both sides are played once. � : both sides are played repeatedly, up to 5 times each side.

MC-30

MICRO

SYSTEM

SHUFFLE

FWD á/ë

RDS/ CLOCK

SIDE A/B

TUNING

SOURCE REPEAT

STOP

PLAY�PAUSE PRESET

TIMER ON�OFF PROGRAM

REW à /í

REV MODE/ BAND RECORD

VOLUME

OPEN

1

Tape playback
Select TAPE source. � The display shows TAPE briefly. The tape counter TAPE 000 display with the A or B and reverse mode status are then shown during tape mode.

General Information on Recording
¶ Recording is permissible insofar as copyright or other rights of third parties are not infringed. ¶ For recording, use only NORMAL (IEC type I) cassette on which the tabs have not yet been broken. This deck is not suited for recording on METAL (IEC IV) type cassettes. ¶ The best recording level is set automatically. Altering the VOLUME, INCREDIBLE SURROUND or DBB controls will not affect the recording in progress. ¶ At the very beginning and end of the tape, no recording will take place during the 7 seconds when the leader tape passes the recorder heads. ¶ To protect a tape from accidental erasure, have the tape in front of you and break out the left tab. Recording on this side is no longer possible. If, however, you wish to record over this side again, cover the tabs with a piece of adhesive tape.

2 3 4 5

Press OPEN to open the tape door.

Insert a recorded tape and close the tape door. ¶ Load the tape with the open side downward and the full spool to the left. Press 2; (on the remote control 2) to start playback.

By pressing à or á on the remote control, fast winding of tape is possible in both directions. ¶ To review and cue at low volume, press REW à / ¡ or FWD á / � on the system. ¶ During fast winding or review/cue you can monitor the tape message with the tape counter. Release the fast wind/cue control at your desired passage.

6

To stop the tape, press 9 . ¶ To reset the tape counter, press 9 again. Note: � The sound source cannot be changed while recording a tape.

16 3140 115 27913

pg 001-021/MC30/22-Eng

16

12/7/00, 1:33 PM