CAD M9
Manual del propietario

Fuse
The fuse holder for the M9 power supply is located on the rear panel. The fuse is a 5mm X 20mm size, 0.08 Amp Slow Blow @ 250v for 220VAC operation, or 0.125 Amp @ 250V for 117 VAC operation. In the event that the fuse needs to be replaced, make sure to select a replacement fuse of equal rating.

M9 Specifications
Type: Side address, true condenser. Capsule: 1.1" inside diameter, gold sputtered. Frequency Response: Capsule: 10Hz - 20 kHz. Head Amplifier: 4Hz - 200KHz Polar Pattern: Cardioid. Impedance: Low (200 ohms nominal). Output Level At 1 kHz.: Open Circuit Voltage: -53 dB (0 dB = 1 volt per microbar). -56 dB (0 dB = 1 volt per microbar). Dynamic Range: 118.5 dB (Noise floor to max SPL @ less than 0.2% THD). 120 dB (Noise floor to max SPL @ less than 5.0% THD). Equivalent Noise Level: 15 dB Equivalent SPL, A weighted. Maximum Output Level: +8 dBV (@ 140 dB SPL, less than 5.0% THD). Maximum SPL: 154.5 dB SPL (-16dB pad). 156 dB SPL (-16dB pad). Total Harmonic Distortion: Less than 0.2% @ 138.5 dB SPL without pad. Less than 5.0% @ 140 dB SPL without pad. Switches: Hi-Pass: (3dB @ 100Hz.) Pad: 0dB & -16dB (Non-Capacitive) Capsule Capacitance: 68 pF. Powering: Included MV200 analog power supply. Connector: 7 pin XLR, on microphone and power supply. 3 pin XLR, audio out from power supply. Cable: Professional quality 7 conductor, 30 ft. long. Gold plated connectors. Finish: Blue housing, satin nickel plated screen assembly with black accents.

Tube Replacement
The tube used in the M9 has been hand selected for low noise, and burned in to provide years of service. The tube used in the M9 is a 12AX7 type. The actual number that appears on the tube in your microphone may be different. This tube is a very popular type used in a variety music and recording related products. However, to insure continued operation within factory specs, it is recommended that you purchase replacement tubes from CAD. Contact the CAD Customer Service Department at 1-888-702-7075. To gain access to the tube, first disconnect the microphone from its power supply. Remove the microphone from the mount by unscrewing the large knob at the bottom of the mic. Remove the mic housing by unscrewing the four screws on the back of the mic. Carefully remove the housing.

M9 Frequency Response and Polar Characteristics

Included Accessories:
30 ft. professional quality 7 conductor cable with gold plated XLR male and female connectors. MV200 Analog Power Supply. Line Cord. Rugged carrying case. Suspension Shock Mount.

Professional Microphones

CAD � 341 Harbor St. � Conneaut, OH 44030 � (440) 593-1111 � Fax (440) 593-5395