Removing the System Memory (RAM)
Figure 4
Removing/ Installing a RAM Module
a. Pull the release latches. b.Remove the module.
The computer has two memory sockets for 200 pin Small Outline Dual In-line Memory Modules (SO-DIMM) supporting DDR 200/266/333MHz. The main memory can be expanded up to 1024MB. The SO-DIMM modules supported are 128Mb, 256Mb, and 512Mb. The total memory size is automatically detected by the POST routine once you turn on your computer.
Memory Upgrade Process
1. Turn off the computer, remove the battery (page 2 - 5) and the bay cover (page 2 - 6). 2. Gently pull the two release latches ( 1 & 2 ) on the sides of the memory socket toward the sides of the computer. a. b. 2 1 3 3
2.Disassembly
Contact Warning Be careful not to touch the metal pins on the module�s connecting edge. Even the cleanest hands have oils which can attract particles, and degrade the module�s performance.
3
The RAM module 3 (Figure 4b) will pop-up, and you can remove it. Pull the latches to release the second module if necessary. Insert a new module holding it at about a 30° angle and fit the connectors firmly into the memory slot. The module will only fit one way as defined by its pin alignment. Make sure the module is seated as far into the slot as it will go. DO NOT FORCE IT; it should fit without much pressure. 7. Press the module down towards the mainboard until the slot levers click into place to secure the module. 8. Replace the memory socket cover and the 6 screws (see page 2 - 6). 9. Restart the computer to allow the BIOS to register the new memory configuration as it starts up.
