CORBERO LVE8010PB
Manual de Usuario

INSTALLATION
Remove all packaging before positioning the machine.

Installing and Securing the Machine Under a Kitchen Unit (Sink-Worktop Unit)
By removing the machine's worktop, you can install it under a close fitting sink unit or a pre-existing top, if the dimensions of the recess correspond to those shown in the picture. Then proceed as follows: Remove the machine worktop by unscrewing the two front retaining screws, pull from the front and slide out the rear slots, lifting the worktop. Insert the machine after adjusting the height and levelling with the adjustable feet. When inserting the machine, ensure that the water inlet and drain hoses are not kinked or squashed.
570÷6 00

Positioning
If possible, position the machine next to a water tap and a drain. The sides and the back of the dishwasher can rest against the adjacent furniture or the wall. The dishwasher features fill and drain hoses which can be turned either to the left or the right to suit the installation.

Levelling
Good levelling is essential for correct closure and sealing of the door. If the door does not close correctly, loosen or tighten the adjustable support feet, until the machine is perfectly level.

600

IN05

Caution
IN01

Once the machine has been installed, ensure that it can be accessed easily for servicing.

Adjusting the Worktop
You can move the worktop forward or backward by 25 mm in order to align the machine with other kitchen units. Simply unscrew the two front retaining screws, move the top to the required position and then retighten the screws.

Fitting a Docor Panel on the Door
The door of this machine has frames for fitting a plastic laminate decor panel in the colour required to match the dishwasher with the rest of the kitchen furniture. If you wish to do this you must provide the panel yourself. Widht: 588 mm Height: 586 mm Max thickness: 4 mm

To Fit the Panel
Take the door frame off after removing the retaining screws around the edge. Position the panel, refit the frame and tighten the retaining screws around the edge.
AP01

IN03

Note: The panel should be fitted before positioning the machine.

PIN09GB

19

820