|
Usuarios conectados
Actualmente hay 5916 visitantes online.
|
Productos
|
Información
|
Destacado
|
|
|
|
|
No hay comentarios de productos.
Rear Panel Features
AC Power
For 120V amplifiers purchased in the USA and Canada, plug in the supplied detachable AC power cable. For 240V amplifiers purchased outside the USA and Canada, you must supply your own detachable AC cable. This cable must have an IEC style 320 connector at one end, and a male AC plug appropriate for your area at the other.
~ 120V / 240V AC 50 / 60Hz - 300W Max
Fuse Holder
The fuse is located within the AC power receptacle on the back of the amp. Access the fuse compartment with a small slotted screwdriver. For 120V amplifiers purchased in the USA and Canada, replace the fuse with: Littelfuse type 21802.5 or equivalent 5 x 20mm, 2.5A, 250V, time delay fuse For 240V amplifiers purchased outside the USA and Canada, replace the fuse with: Littelfuse model 2181.25 or equivalent; 5 x 20mm, 1.25A, 250V, time delay fuse.
TM
Effects Loop (Serial)
Patch an external effect (delay, reverb, chorus) through these jacks. Use a standard 1/4� instrument cable to connect the send on the Loudbox to the input of the effect. Connect the return jack on the Loudbox to the output of the effect. The effects loop is located �post-EQ�. The effects loop is compatible with battery operated �stompbox� style effects processors. You may also connect the send jack on the Loudbox to an external tuner or to an additional stage amp.
TM
XLR Output
Use this balanced output to route your instrument�s signal to a mixing console, PA, etc. This output is �post-fader� and �post-EQ�, which means that all the front panel controls (excluding the phase switch) will affect the signal that gets to the XLR output.
Kickstand
To hear yourself better onstage, use the kickstand to angle the Loudbox back like a wedge style floor monitor. The kickstand has three click-stops that enable you to tilt the cabinet back to a 45, 57 or 70 degree angle. Squeeze the buttons on the side of the kickstand to unlock the pivot mechanism, then select the angle that you prefer. Gently tilt the Loudbox back onto the kickstand. The closer you stand to the amp, the more angle you�ll need to get the Loudbox pointed at ear level.
8
|
|
|
> |
|