|
Usuarios conectados
Actualmente hay 6043 visitantes online.
|
Productos
|
Información
|
Destacado
|
|
|
|
|
No hay comentarios de productos.
Using Your Dryer
1.
2.
l
Put the sorted load In the dryer and close the door tightly. Turn the Cycle Control the cycle you want. Knob to
Use the Automatrc Cycles for most loads. Start wrth the pornter at the mrddle of an Automatrc Cycle. See page 6 for more informatron. Cycles, the Cycle Control Knob does not keep moving. It starts and stops, depending on the heat and the dryness of the load.
NOTE: In the Automatic
-1
2
l
Use TIMED DRYING for drying a certain number of minutes, or for damp drying. fluffing, or tumbling items without air.
Setting Drying Times Modern dryers are designed with drying temperatures needed to safely handle modern fabrics. Cooldown times have been added to heat settings. You might notice slightly longer drying times. The time it takes to dry a load depends on:
3.
l
Set TEMPERATURE SELECTOR.
Turn the TEMPERATURE SELECTOR to for the
temperature needed load. See page 5 for suggested settings.
the drying
4.
l
Push the Start Button.
Make sure the door is closed and the Cycle Control is set. If the door IS opened during the cycle, the dryer will stop. To restart the dryer, close the door and push the Start Button.
0 The kind of fabric, its weight, and the size of the load. A large load of jeans
will take a lot longer to dry than small load of light synthetics. a
0 The amount
of moisture
in the load.
synthetics
Towels hold a lot of moisture; don�t. Synthetics dry faster.
l
5.
l
To stop the dryer:
Control Knob to one
Open the door. l Or, turn the Cycle of the OFF positions.
l
To change the setting while dryer is running, turn the Cycle
the
Knob, either way. so it points ting you want.
Control to the set-
Cold rinses help save on energy and wrinkles, but a cold load will take slightly longer to dry than a warm one. l Amount of linf on the screen. A full lint screen slows the air flow and can make drying time longer. l Temperature around the dryer. The dryer heats room air. If the room air temperature is not above 45°F (7.2�(Z), drying time will be longer and removal of wrinkles may be poor.
Temperature
of the rinse water
0 Proper instollotion tems. For the fastest
IMPORTANT: To help reduce wrinkling, take the load from the dryer as soon as tumbling stops. This is very important and other for permanent press, synthetic fabrrcs. knits time, dryer lation
and exhaust
possible
sys-
drying
installing and exhausting your properly is important. See instalinstructions.
4
|
|
|
> |
|