|
No hay comentarios de productos.
MANUAL TUNING
When an FM stereo broadcast contains Inoise
Press the BAND/MODE TUNER button while pressing the SHIFT button on the remote control. �MONO� appears on the display. Noise is reduced, although reception is monaural. m
BANDI MODE TUNER SHIFT To restore stereo reception, press the buttons again.
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step. If you use this unit in an area where the frequency allocation system is 9 kHz/step, change the tuning interval. Press the POWER button while pressing the TUNER button during power on. TO reset the interval, repeat this procedure,
1 Press the TUNER button repeatedly to select the desired band.
Bm
q
m
If the power is turned off, the previously tuned station will be played (Direct Play Function). \AJhen using the remote control, press the BAND/MODE �WNER button repeatedly while power is on.
When the AM tuning interval is changed, all preset stations (see �PRESETTING STATIONS�) are cleared. The preset !stations have to be set again.
2 Press the q<
or ®> button to select a station.
changes. for 2 seconds.
Each time the button is pressed the frequency \Nhen a station is received, �TUNE�r is displayed During FM stereo reception, �STEREO�
is displayed.
To search for a station quickly (Auto Search)
Keep the +< or
®F
button
pressed
until the tuner
starts
searching for a station, Stolps, To stop the Auto Search * The Auto signals. Search
After tuning manually,
in to a station,
the search �~ button.
press the <<or
may not stop at stations
with very weak
7
ENGLISh!
|
