|
|
|
Usuarios conectados
Actualmente hay 5786 visitantes online. |
|
Productos
|
|
Información
|
|
Destacado
|
|
|
 |
|
|
No hay comentarios de productos.
LC-20E1H LC-20E1M
ADJUSTING PROCEDURE OF EACH SECTION
The best adjustment is made before shipping. If any position deviation is found or after part replace is performed, adjust as follows.
1. Preparation for Adjustments
(1)Use the exclusive-use AC adapter or stable DC power supply. AC adapter: UADP-0241CEPZ DC power supply: 13 ± 0.5V 5.4A
[1] Adjustment Procedure
1-1. Adjusting the checker Turning on the power (initialization) � Setting the model and size in inches � Transferring the model-specified data to the E2PROM (I2C) � Calling the adjustment process mode � Starting the adjustment (+B adjustment) 1-2. Adjusting the finish process Reassembling the set � Turning on the power � Calling the adjustment process mode (using the remote controller) � Adjusting the counter bias, TV contrast and white balance
[2] Calling the MAIN adjustment process mode
There are the following two ways to choose from. � Set the Pin (81) (KEY4) or Pin (82) (KEY5) of IC2001 (microprocessor) to "L", turn on the power. � For servicing, hold down the TV/VIDEO and MENU keys at once, and turn on the POWER switch. (Make sure the process mode "K" appears at the top left of the screen.) Then press the CH DOWN and VOL DOWN keys at once. (Make sure the adjustment process mode screen shows up.) To quit this mode, turn off the power. (Or turn off the POWER switch or use the remote controller�s OFF key.)
[3] Using the keys for the adjustment process
Selecting a reception channel � Using the CH UP/DOWN key, turn up and down reception (broadcasting) channels. Just click on the key, and channels are selected on by one. Hold down the key, and the next receivable channel is searched up and down. � Adjustment items Adjust each of the items by using the MENU SELECT, CURSOR UP/DOWN and VOL UP/DOWN keys (on the set or on the remote controller). � Select an adjustment item using the CURSOR UP/DOWN key. � An adjustment item is toggled on and off by activating the MENU SELECT key (next item). Let�s suppose that the item at the bottom of a page is now selected. When the MENU SELECT key is activated here, the item at the top of the next page will be selected.
[4] Initialization
4-1. Set pins (81) and (82) of IC2001 (microprocessor) to GND. Turn on the power. 4-2. Select a model number (E1H). 4-3. Select the inch size (20).
13
|
|
|
> |
|
