SHARP LC20B6M
Manual de Usuario

Basic Operation (Continued)
Sound Volume
� To adjust the volume

Changing Channels

You can select channels using Channel Select or CH (

)/(

).

� To handle the increasing number of channels available, this LCD TV set allows you to select up to 100 positions (Channels 0 to 99). One-digit and two-digit methods of selection can be used. Follow the procedure shown below to select channels.

� Press VOL (+) to increase the sound volume. The numerical value increases. Volume 50 � Press VOL (�) to decrease the sound volume. The numerical value decreases. Volume 10

� Using Channel Select

To select a one-digit channel (e.g., Channel 5):

1 2

Press 5 of Channel Select. If �5-� is indicated and the picture does not change, press -/-- to switch over to the 1-digit select mode and press 5 of Channel Select.

1
PAL B/G

� To mute the sound
� Press e (Mute) to temporarily turn off the sound. The MUTE mark is displayed on the screen.

To select a two-digit channel (e.g., Channel 15):

1

Press -/-- to set the 2-digit select mode.

--

2
� Press e (Mute) or VOL (+)/(�) to turn the sound back to the previous level. MUTE is automatically cleared when one of the following buttons are pressed: POWER, VOL (+)/(�) or e (Mute). Volume 10

Press 1 of Channel Select.

1-

3

Press 5 of Channel Select.

15
PAL B/G

NOTE � Complete this procedure within 4 seconds, otherwise the selection will not be made.

Changing channels with CH ( control.
Press CH ( 1�2�3 Press CH ( 3�2�1

)/(

) on the remote

) and the channels change in the order shown below: � . . . � 98 � 99 � 0 � 1 � 2 � 3 � . . . ) and the channels change in the order shown below: � 0 � 99 � 98 � . . . � 3 � 2 � 1 � . . .

� Using A (Flashback)
� Press A to switch the currently tuned channel to the previously tuned channel. � Press A again to switch back to the currently tuned channel.

11