Your washer has the SUDS-MISER System.jt has two drain hoses One hose moves a portion of used wash water Into a storage tub and moves it back Into the washer for use during the next wash The other hose carries water to another tub wrth an open dram, or to a standprpe drain If you do not want to re-use wash water for a load. leave the stopper out of the storage tub so the water drains away
STORAGE run \ SIANDPIPE
The SUDS-MISER� System stores a portron of the wash water. If you hove a storage tub big enough to hold 25 gallons (95 liters) of water, you can have a qualified installer convert your washer to save more of the water.
To save wash water
Be sure the stopper is in the storage tub. The SUDS-MISER System does not save rinse water from any cycle, nor does it save wash water from the PERMANENT PRESS Cycle. 1. Set Cycle Control Knob on SUDS (see illustration). 2. Pull the Control Knob out. The washer will pump most of the water from the storage tub back into the washer basket. Do not add clothes at this time. The washer will finish filling with fresh water 3. When the water has pumped back into the washer, push the Cycle Control Knob. in I
To re-use wash water
4. Add about �2 the recommended amount of detergent. 5. Put in the clothes. 6. Pull out the Cycle Control Knob to start the washer. 7. Drain the storage tub. Water still in the tub will have any soil that has settled out. The hose is cut on an angle to leave behind about an inch of water and any soil from previous wash. If You want a cycle other than REGULAR HEAVY to follow SUDS, push in the Cycle Control Knob after the water has been pumped back into the washer. Turn the knob right (clockwise) to the cycle and wash time You want
