,...._______________. the desired disconnect time appears until
.~I
[19] [NEXT] [k] [SELiCT]
[MEMORY] [END]
;9] [NEXT] [NEXT] [SELECT] [MEMORY][END]
--.--- until the desired CO rlumber appears
esc
A certain amount of time is needed for a outside call to be released, this is necessary so that new calls may be attempted after disconnecting with the previous calls. There are two choices available, 1.5 and 4.0 seconds. The time you select must be longer than the requirements from your Central Office or host PBX.
6. Repeat steps 3 to 5, to set the disconnect time .for the other CO�s. 7. To return to the initial program mode, press the END button.
s
start the programming from step 1, you may dial the desired CO number instead of the NEXT button at step 3. The PREV button allows you to go to the previous CO for displaying the disconnect time.
L(
d. Dial (19). �DISCONNECT
TIME�
will be displayed. 4.0 set on all 3 CO=
[19] [NEXT] [x] [SELECT] [MEMORY] [END]
2. Press the NEXT button. �ENTER CO NO� will be displuyed. 3. Press the NEXT button. �CO 1: 1.5 SEC� will be displayed �1.5 SEC� will blink.
. Press the SELECT
and
button to alternate between 1.5 set and 4.0 sec. See pqe 5-16.
5. Press the MEMORY butto,l. The blinking LCD will stop.
