5.4.6. RESET THE CAMERA TO THE FACTORY DEFAULT SETTINGS
The Network Camera has an CLEAR SETTING button which located back panel.
To Reset the Camera to the Factory Default Settings If any of the user settings or password were forgotten the Network Camera can be easily reset to the factory default settings. With power applied easily reset to the factory default settings. With power applied, press the "CLEAR SETTING" for about-1 second. The green LED on the front of the camera will first go out, and will blink for about 45 seconds during which time the pan-tilt motors will reposition themselves. The entire procedure takes about 1 minute. The reset is located on the rear of the camera and is accessed through the hole in the case using a pointed object. Caution:
When you press the CLEAR SETTING button, all buffered images are cleared.
6. DIAGNOSTICS
6.1. SELF TEST
The KX-HCM 10 checks its own hardware when the power turns on. The following table shows the contents of the check.
