2-10. PICTURE TUBE � REMOVAL OF ANODE-CAP
NOTE : After removing anode, short circuit anode of the picture tube and CRT. 4 C5 board
3 F board anode cap to metal chassis, CRT shield or carbon paint on the
� REMOVING PROCEDURES 7 Neck assy
2 A board
a
5 Deflection yoke a
6 Four screws
(Tapping screws) 1 Turn up one side of rubber cap in direction indicated by the arrow a.
b b
1 Anode cap
2 Using a thumb pull up rubber cap firmly in direction indicated by the arrow b.
c
� 25 �
Cushion 3 When one side of rubber cap is separated from anode button, the anode-cap
can be removed by turning rubber cap and pulling it up in direction of the arrow c.
Anode button
� HOW TO HANDLE AN ANODE-CAP
1 Do not damage the surface of anode-caps with sharp shaped objects. 2 Do press rubber too hard so as not to damage the inside of anode-cap. A metal fitting called shatter-hook terminal is built into the rubber. 3 Do not turn the foot of rubber over too hard. The shatter-hook terminal will stick out or damage the rubber.
