SONY KVXA34M97
Manual de Servicio

KV-XA29M67/XA29M97/XA34M67/XA34M97

Using Your New TV

Getting Started
CAUTION � Do not connect the power cord until you have completed making all other connections; otherwise a minimum leakage current might flow through the antenna and other terminals to ground. � To avoid battery leakage and damage to the remote, remove the batteries from the remote if you are not going to use it for several days. If any liquid that leaks from the batteries touches you, immediately wash it away with water.

Step 1
Connect the antenna
If you wish to connect a VCR, see the Connecting a VCR diagram below.
Rear of TV

Notes � If you connect a monaural VCR, connect the yellow plug to (the yellow jack) and the black plug to -L (MONO) (the white jack). � If you connect a VCR to the 8 (antenna) terminal, preset the signal output from the VCR to the program number 0 on the TV. � If both (S video input) and � 1 (video input) at the rear of your TV are input at the same time, the (S video input) is automatically selected. To view the video input to t 1 (video input), disconnect the S video cable. � Do not connect video equipment to t 3 (video input) at the front and the rear of your TV at the same time; otherwise the picture will not be displayed properly on the screen. � When no signal is input from the connected video equipment, the TV screen becomes blue.

Using Your New TV

RM-953

Step 2
Insert the batteries into the remote

or

Antenna cable (not supplied)

IEC connector (not supplied)

� 8 �
Connecting a VCR
To antenna output
AUDIO VIDEO R VIDEO IN VIDEO OUT L

Note � Do not use old batteries nor use different types of batteries together.
Antenna cable (not supplied) : Signal flow

Step 3
Preset the channels automatically
Front of TV

To watch the video input, press t (see page 11).
Antenna cable (not supplied)

Rear of TV

VCR To 8 (antenna)
WOOFER

1

R

L

Y

CB

CR
L(MONO)

4

S video cable (not supplied)

1

2

3

ENTER

SELECT

3

MENU

AUTO PROGR

PROGR

2

To video and audio outputs

To S video output

To (S video input) (yellow) -L (MONO) (white) -R (red)

To t 1, 2 or 3 (video input)

Audio/Video cable (not supplied)

Tips � If you want to stop the automatic channel presetting, press MENU. � If your TV has preset an unwanted channel or cannot preset a particular channel, then preset your TV manually (see page 31).

4

Using Your New TV

: Signal flow

Using Your New TV

5