|
|
|
Usuarios conectados
Actualmente hay 5611 visitantes online. |
|
Productos
|
|
Información
|
|
Destacado
|
|
|
 |
|
|
No hay comentarios de productos.
KV-36FS12/36FS16/36FV16/36FV26
Handling of Self-Diagnostic Screen Display
Since the diagnostic results displayed on the screen are not automatically cleared, always check the self-diagnostic screen during repairs. When you have completed the repairs, clear the result display to �0�. Unless the result display is cleared to �0�, the self-diagnostic function will not be able to detect subsequent faults after completion of the repairs. Clearing the Result Display To clear the result display to �0�, press buttons on the Remote Commander sequentially when the diagnostic screen is displayed, as shown below:
Channel 8 ENTER
Quitting the Self-Diagnostic Screen To quit the entire self-diagnostic screen, turn off the power switch on the Remote Commander or the main unit.
Self-Diagnostic Circuit
A BOARD IC355 Y/CHROMA JUNGLE
A BOARD IC561 V. OUT
A BOARD IC001 SYSTEM
A BOARD IC1002 MEMORY
FROM C BOARD IC1701 PIN1 A BOARD FROM IC501 PIN 1
21 IK IN REF 3 15 VM
IO-BDATN 26
5
BDA
18 HP/PROTECT O-TIMELED SDA 35 27 IO-SDATN 59 DISPLAY
+B overcurrent (OCP)
Occurs when an overcurrent on the +B (135V) line is detected by pin 18 of IC355 (A Board). If the voltage of pin 18 of IC355 (A Board) is less than 1V when V.SYNC is more than seven verticals in a period, the unit will automatically turn off. Occurs when the feedback circuit from +B opens IC643 or T603 or any other associated feedback components. Occurs when an absence of the vertical deflection pulse is detected by pin 15 of IC355 (A Board). Power supply will shut down when waveform interval exceeds 2 seconds. If the RGB levels* do not balance within 2 seconds after the power is turned on, this error will be detected by IC355 (A Board). TV will stay on, but there will be no picture. *(Refers to the RGB levels of the AKB detection Ref pulse that detects 1K).
+B overvoltage (OVP)
V-Stop
IK (AKB)
NOTE: Watch Dog Timer
Indicates how many times the Watch Dog Timer functions have been activiated. Whenever micro is reset by the Watch Dog Timer, this number is incremented. Maximum number is 255.
�6�
|
|
|
> |
|
