Setting Up the Channel List
After you finish connecting your TV, you need to run Auto Setup to set up your channels. The Auto Program screens appear when you turn on your TV for the first time after hooking it up.
Using Auto Program
To run Auto Program the first time you turn on your TV
1 Press POWER to turn on the TV.
The Initial Setup screen appears.
2 Press V v to move the highlight to the desired language, then
press
z
to select that language.
To exit the Tilt Correction
3 The next screen instructs you to connect your cable/antenna.
Check that you�ve connected your signal source properly. To start Auto Program, highlight Yes and then press . Auto Program automatically creates a list of receivable channels. When Auto Program is finished, the Tilt Correction screen appears.
and Vertical Correction screens, press the MENU button.
z For more details on using Auto Program, see page 52.
For more details on using Tilt Correction and Vertical Correction, see page 59.
4 Press B b to correct any tilt of the picture. You can choose a
correction between +7 and -7. When finished, press .
5
The Vertical Correction screen appears. Press V v to make a vertical correction to the picture. You can choose a correction between +5 and -5. When finished, press .
KV-30/34HS420 Only
When completed, the lowest numbered channel is displayed.
To reset the TV to factory settings
1 Press POWER to turn on the TV. 2 Hold down RESET on the remote control. 3 Press TV POWER on the TV. (The TV will turn itself off, then back
on.)
