REMOVAL OF ANODE-CAP
carbon paint on the CRT, after removing the anode.
Note: Short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield or
* REMOVING PROCEDURES.
Degaussing coil 4
a
b b
c
Anode button
1 Turn up one side of the rubber cap in the direction indicated by the arrow a
Spring Tension
5
2 Using a thumb pull up the rubber cap 3 When one side of the rubber cap is firmly in the direction indicated by the separated from the anode button, the arrow b anode-cap can be removed by turning up the rubber cap and pulling it up in the direction of the arrow c
2 Chassis assy
C Board
6
�
VM Board Neck Assy Deflection Yoke
7 8
HOW TO HANDLE AN ANODE-CAP Don't damage the surface of anode-cap with sharp shaped material ! Don't press the rubber hardly not to hurt inside of anode-caps ! A metal fitting called as shatter-hook terminal is built into the rubber. Don�t turn the foot of rubber over hardly ! The shatter-hook terminal will stick out or damage the rubber.
