KS-FX480
REFERENCE: Prior to performing the following procedures, turn the mode gear on the bottom of the body until the respective part comes to the EJECT position (Refer to Fig.1).
Removing the reinforce bracket (See Fig.1 and 2)
1. Remove the screw A attaching the reinforce bracket on the bottom of the body. 2. To release joint a, turn and detach the reinforce bracket from the side bracket assembly as shown in Fig.2
Mode gear Reinforce bracket
A
Fig.1
Removing the cassette guide (See Fig.3)
1. Turn the mode gear to set to RVS play or subsequent mode. 2. Remove the cassette guide from the main chassis while releasing each two joint tabs b in the direction of the arrow.
Joint a
Reinforce bracket
Removing the head board (See Fig.4)
1. Remove the screw B on the upper side. Unsolder the wires on the under side of the head board, if necessary. REFERENCE: When reassembling, twist the wires by turning the head board twice remarked c and pass through the notch d as shown in Fig.4.
