PIONEER KRP-S01/XTW/CN5
Manual de Servicio

1

2

3

4

1. REASSEMBLY AND DISASSEMBLY PRECAUTIONS
A

1.1 GRILLE ASSY
The Grille Assy is secured to the baffle plate with adhesive double side coated tape and bosses. When removing the Grille Assy, it is necessary to wear cotton gloves. Remove it from the under side. 1. Insert the tip of your gloved finger into the gap between the Grille Assy in front and the corner of the baffle plate so that the Grille Assy is slightly lifted.

Reassembly
Remove the old adhesive double side coated tape attached between the rear side of the Grille Assy and the front side of the Baffle, and then attach new one. Press the bosses into the baffle plate and press the entire grille into position.

Disassembly

1.2 WOOFER
Disassembly
The woofer is attached to the baffle plate by internal four screws. To remove the woofer, first remove the baffle plate.

B

Reassembly
When reassembling the woofer, face its plus terminal downward. Tighten the screws to the baffle.

1.3 TWEETER
2. Insert the gloved finger to the extent of the second joint into the gap between the cabinet and the Grille Assy.

Disassembly
The tweeter is attached to the baffle plate by internal two screws. To remove the tweeter, first remove the baffle plate.

Reassembly
When reassembling the tweeter, face its plus terminal outside.
C

Network Assy(Caution)
When removing the Network Assy, pull it out a little at a time from alternate sides, because it is seated tightly. 3. Alternately and gradually lift the left and right sides of the Grille Assy by about 5 cm, sliding gloved fingers along the cabinet. When lifting the Grille Assy, be sure to lift the left and right side alternately, but not both sides simultaneously.
1

2 1
Input terminal

D

When reassembling it, apply a adhesive to the screws. Network ASSY

Note: Be careful not to bend the Grille Assy too far. Otherwise, it may be damaged. OK : Good example NG : Bad example

Grille ASSY

E

OK
Baffle Assy(Caution)
Grille ASSY

When reassembling the cabinet and the baffle plate, secure the screws in the order shown in the figure below:
13 10 8 6 4 3 2

NG
F

12 11

9

7

5

1

2
1 2

KRP-S01
3 4