KENWOOD KRFV4530D
Manual de Usuario

Recording

Recording video
1 Use the INPUT SELECTOR to select the video source (other than �VIDEO1 �) you want to record. 2 Set the video deck connected to VIDEO 1 to record. � Select the REC MODE to record a digital input source. 3 Start playback, then start recording. � With certain video software, recording may not be normal due to the copy guard condition. �

Recording music in M-REC MODE
DIMMER

19

Recording audio (digital sources)
Switch on the REC MODE to record a digital input source. Usually use the A-REC MODE to record audio input sources. When the digital mode changes during recording in the A- REC MODE, the audio may be interrupted momentarily. To record the audio from the beginning of the digital mode change, use the M-REC MODE. With a model that is not compatible with DTS, no audio is reproduced even when the DTS signals are input.

INPUT SELECTOR
1 Use the input selector to select the source (CD, DVD,VIDEO2, or VIDEO3) you want to record. 2 Set the cassette deck to record. 3 Play the source to be recorded. 4 Press and hold the DIMMER key for more than 2 seconds to select the MREC MODE. � The mode changes every 2 seconds as shown below.

Recording music in A-REC MODE
DIMMER

1REC MODE off : 2A-REC MODE :

3M-REC MODE :

The digital input record mode is switched off. The digital input signals (DTS, Dolby Digital or PCM) are identified automatically and converted into stereo signals that are ready for recording. The input signal type at the moment this mode is selected is held throughout this mode.
FM AUTO SOUND DIGITAL AUTO AM PRO LOGIC S.DIRECT MEMO MHz 3 STEREO MONITOR ST. kHz DOWN MIX DSP TUNED

INPUT SELECTOR
1 Use the INPUT SELECTOR to select the source (CD, DVD, VIDEO2, or VIDEO3) you want to record. 2 Set the cassette deck to record. 3 Press and hold the DIMMER key for more than 2 seconds to select the AREC MODE. � The mode changes every 2 seconds as shown below. 1REC MODE off : 2A-REC MODE : The digital input record mode is switched off. The digital input signals (DTS, Dolby Digital, or PCM) are identified automatically and converted into stereo signals that are ready for recording. The input signal type at the moment this mode is selected is held throughout this mode.

FM AUTO SOUND DIGITAL AUTO AM PRO LOGIC S.DIRECT MEMO MHz 3 STEREO MONITOR ST. TUNED kHz DOWN MIX DSP

5 Play the source from the beginning and start recording. � If the audio reproduction stops in the middle due to change in the input signals, etc., press the DIMMER key.

3M-REC MODE :

FM AUTO SOUND DIGITAL AUTO AM PRO LOGIC S.DIRECT MEMO MHz 3 STEREO MONITOR ST. kHz DOWN MIX DSP TUNED

FM AUTO SOUND DIGITAL AUTO AM PRO LOGIC S.DIRECT MEMO MHz 3 STEREO MONITOR ST. kHz DOWN MIX DSP TUNED

4 Start playback, then start recording. � If the audio reproduction stops in the middle due to change in the input signals, etc., press the DIMMER key.

Operations